Installation manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
© Copyright 2008, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any
means without the expressed written consent of the publisher.
F232064
1
Table of
Contents
Introduction......................................................................................... 2
Model Identification ............................................................................. 2
Nameplate Location.............................................................................. 3
Replacement Parts ................................................................................ 3
Customer Service.................................................................................. 3
Safety Information.............................................................................. 4
Explanation of Safety Messages........................................................... 4
Important Safety Instructions ............................................................... 4
Safety Decals ........................................................................................ 6
Operator Safety..................................................................................... 7
Programming ...................................................................................... 8
P-Series Microcomputers...................................................................... 8
Key Functions In Programming Mode ................................................. 8
Setup Mode........................................................................................... 8
Run Mode or Test Mode .................................................................. 8
Vend Price Enabled or Disabled ...................................................... 9
Coin Blocking Coil or Supply 3....................................................... 9
1 or 4 Amounts to Start.................................................................... 9
Coin Value ....................................................................................... 9
Amount to Start................................................................................ 9
Cycle Programming .............................................................................. 9
Entering Program Mode................................................................... 10
Programming a Cycle ...................................................................... 10
Supply Dispenser .................................................................................. 12
Cycle Segment Charts........................................................................... 13
P-Computer Cycle Charts ..................................................................... 16