Installation manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
13
F232064
Cycle Segment Charts
Segment 1 (Prewash)
Display
Instructions
Use the Cold/Normal or Cold/Delicate key to change.
Press the Warm key to advance.
PrE
00 or 60 to 1800 Select segment time: 60 to 1800 seconds (00 to skip segment)
HFIL, CFIL, or bFIL Select “HFIL” (hot fill), “CFIL” (cold fill), or “bFIL” (warm fill)
LOLE, HILE,
or SLUC
Select fill level: “LOLE” (low water level), “HILE” (high water level), or “SLUC” (overflow
fill)
nSUP or SUP Select “nSup” (supply step disabled) or “SUP” (supply step enabled)
SUP1–SUP3* Select supply 1–3
SPIn (flashed for one second)
tINE (flashed for one second)
00 or 60 to 120 Select time for spin: 60 to 120 seconds (00 for no spin)
* Available only if “SUP” is selected. “SUP3” is available only if the “S3”/“CoiL” setup option is set to “S3.”
Tabl e 6
Segment 2 (Wash)
Display
Instructions
Use the Cold/Normal or Cold/Delicate key to change.
Press the Warm key to advance.
UASH
00 or 60 to 1800 Select segment time: 60 to 1800 seconds (00 to skip segment)
HFIL, CFIL, or bFIL Select “HFIL” (hot fill), “CFIL” (cold fill), or “bFIL” (warm fill)
LOLE or HILE Select fill level: “LOLE” (low) or “HILE” (high) water level
nobL or bL Select “nobL” (supply step disabled) or “bL” (supply step enabled)
nSUP or SUP Select “nSup” (supply step disabled) or “SUP” (supply step enabled)
SUP1–SUP3* Select supply 1–3
SPIn (flashed for one second)
tINE (flashed for one second)
00 or 60 to 120 Select time for spin: 60 to 120 seconds (00 for no spin)
* Available only if “SUP” is selected. “SUP3” is available only if the “S3”/“CoiL” setup option is set to “S3.”
Tabl e 7
Cycle Segment Charts (continued)