Installation manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
9
F232064
Vend Price Enabled or Disabled
This setup option determines whether or not the vend
price must be met before a cycle can be started. If
“PAY” is selected, the vend price must be met. If
“FrEE” is selected, no vend amount is necessary to
start a cycle.
Coin Blocking Coil or Supply 3
This setup option determines whether the computer
controls a coin blocking coil or allows a supply 3 to be
programmed. If “CoiL” is selected, the computer will
control a coin blocking coil. If “S3” is selected, supply
3 will be available for programming.
1 or 4 Amounts to Start
This setup option determines whether a single vend
price will be used to start any cycle or a separate vend
price will be used to start each cycle.
If “1AtS” is selected, a single vend price will be used
for all four cycles. When in RUN mode, the display
will flash “PAY” alternately with the vend price.
If “4AtS” is selected, each cycle will have a separate
vend price. When in RUN mode, the display will scroll
through the four cycles, alternately showing the
respective vend price for each cycle.
Coin Value
This setup option establishes the value of the coin type
accepted by the coin meter. Use the Cold/Normal and/
or Cold/Delicate keys to set this value. If either of
these keys is pressed and held, the displayed value
changes more rapidly.
Amount to Start
This setup option sets the vend price (or prices)
necessary to start a cycle. If “1AtS” was selected
during setup, one value will be available for
modification. If “4AtS” was selected during setup, the
vend price for each cycle will be available for
modification. Use the Cold/Normal and/or Cold/
Delicate keys to set the vend price value(s). If either of
these keys is pressed and held, the displayed value
changes more rapidly.
Cycle Programming
To edit an existing cycle, press the Hot key while the
display is showing “Pro.” The display will show “CY
?” Press the key which corresponds to the desired
cycle (Hot, Warm, Cold/Normal and Cold/Delicate).
The display will show “PrE.” The computer is now in
cycle programming mode.
All 4 cycle programs can be customized within a
preset program structure. Each cycle program consists
of 6 program segments. See
Table 1.
When modifying a cycle, a time must be entered for
each segment. To skip a segment or spin, set the time
to “00.” Refer to
Table 2 for time parameters for each
segment and spin.
Cycle Program Segments
Segment Display Segment Display
Prewash PrE Rinse 2 rin2
Wash UASH Rinse 3 rin3
Rinse 1 rin1 Rinse 4 rin4
Table 1
Time Parameters
Function Minimum Maximum
Prewash 60 seconds 1800 seconds
Wash 60 seconds 1800 seconds
Rinse 1 60 seconds 300 seconds
Rinse 2 60 seconds 300 seconds
Rinse 3 60 seconds 300 seconds
Rinse 4 60 seconds 300 seconds
Intermediate Spin 60 seconds 120 seconds
Final Spin 60 seconds 600 seconds
Table 2