Installation manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
F232064
8
Programming
P-Series Microcomputers
The computer board is inside the control module. Near
the center of the board is a small toggle switch: this is
the RUN/PROGRAM mode switch.
The switch is normally in the up (RUN mode)
position. To enter PROGRAM mode, flip the switch to
the down position. The display will now show “Pro.”
Since the keypad operates in a slightly different
fashion when in PROGRAM mode, pay careful
attention to the programming instructions provided in
this manual.
Key Functions In Programming
Mode
Hot–The Hot key is used to enter and exit cycle
PROGRAM mode. The Hot key can also be used to
exit SETUP mode.
Warm–The Warm key is used to scroll forward
through program segment steps and setup options.
Cold/Normal–The Cold/Normal key is used to scroll
forward from segment to segment, to increase
numerical values such as step times, coin
denomination, and vend prices, and to switch between
available options.
Cold/Delicate–The Cold/Delicate key is used to enter
SETUP mode. The Cold/Delicate key is also used to
scroll backward from segment to segment, to decrease
numerical values such as step times, coin
denomination, and vend prices, and to switch between
available options.
Setup Mode
Setup options are programmable options that are in
effect for all wash formulas. These options include:
● RUN mode or TEST mode
● Vend price enabled or disabled
● Coin blocking coil or supply 3
● 1 or 4 amounts to start
● Coin value
● Amount to start
To enter SETUP mode, press the Cold/Delicate key
while the display is showing “Pro.” Once in SETUP
mode, use the Cold/Normal or Cold/Delicate key to
change the selected option. Use the Warm key to
accept the selected option and move on to the next one.
Press the Hot key at any time to exit SETUP mode.
Run Mode or Test Mode
This setup option allows the machine to be placed in
TEST mode for troubleshooting purposes. When in
TEST mode, the computer allows one cycle to be run
without having to meet the vend price. While that
cycle is running, pressing the keypad keys will
advance the cycle to the next cycle step. The computer
returns to RUN mode upon completion of the test
cycle.
If “tESt” is selected, the machine will be in TEST
mode when the RUN/PROGRAM switch is placed in
the RUN (up) position. If “norN” is selected, the
machine will be in RUN mode when the RUN/
PROGRAM switch is placed in the RUN (up) position.