Specifications

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Safety Information
5
C003292ENR1
IMPORTANT: Ensure that the recommended
clearances for inspection and maintenance are
provided. Never allow the inspection and
maintenance space to be blocked.
Safety Decals
Safety decals appear at crucial locations on the
machine. Failure to maintain legible safety decals
could result in injury to the operator or service
technician.
Use manufacturer-authorized spare parts to avoid
safety hazards.
Operator Safety
The following maintenance checks must be performed
daily:
1. Verify that all warning signs are present and
legible, replace as necessary.
2. Check door interlock before starting operation of
machine:
a. Attempt to start machine with door open.
Machine should not start.
b. Close door without locking it and attempt to
start machine. Machine should not start.
c. Attempt to open door while the cycle is in
progress. The door should not open.
If door lock and interlock are not functioning
properly, disconnect power and call a service
technician.
3. Do not attempt to operate machine if any of the
following conditions are present:
a. Door does not remain securely locked during
entire cycle.
b. Excessively high water level is evident.
c. Machine is not connected to a properly
grounded circuit.
Do not bypass any safety devices in machine.
Machine installations must comply with
minimum specifications and
requirements stated in the applicable
Installation Manual, any applicable
municipal building codes, water supply
requirements, electrical wiring
regulations and any other relevant
statutory regulations. Due to varied
requirements and applicable local codes,
this machine must be installed, adjusted,
and serviced by qualified maintenance
personnel familiar with applicable local
codes and the construction and operation
of this type of machinery. They must also
be familiar with the potential hazards
involved. Failure to observe this warning
may result in personal injury, property
damage, and/or equipment damage, and
will void the warranty.
W820
WARNING
Never touch internal or external steam
pipes, connections, or components.
These surfaces can be extremely hot and
will cause severe burns. The steam must
be turned off and the pipe, connections,
and components allowed to cool before
the pipe can be touched.
SW014
WARNING
NEVER insert hands or objects into
basket until it has completely stopped.
Doing so could result in serious injury.
SW012
WARNING
Operating the machine with severe out-of-
balance loads could result in personal
injury and serious equipment damage.
W728
WARNING