Specifications

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Maintenance
45
C003292ENR1
3. Verify V-belts are properly aligned by checking
pulley alignment. Place a straight edge across
both pulley faces. The straight edge should make
contact with pulleys in two places. Refer to
Figure 25.
Figure 25
4. Check all hoses for leaks, cracking and
deterioration.
5. Check supply dispenser hoses and hose
connections for leaks.
6. Clean inlet hose filter screens:
a. Turn water off and allow valve to cool, if
necessary.
b. Unscrew inlet hose and remove filter screen.
c. Clean with soapy water and reinstall. Replace
if worn or damaged.
7. Tighten motor mounting bolt locknuts and
bearing bolt locknuts, if necessary.
8. Verify that motor plate mounting bolt is tight but
plate is free to pivot.
9. Use compressed air to clean lint from motor.
10. Clean interior of machine, both basket and shell,
by wiping with a water-soaked sponge or cloth.
11. Use compressed air to ensure that all electrical
components are free of moisture and dust.
12. Remove chemical supply components and check
for residual chemicals. Clean as necessary and
replace.
Quarterly
NOTE: Disconnect power to washer-extractor
before performing quarterly maintenance
procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Tighten anchor bolts, if necessary.
3. Verify that drain motor shield is in place and
secure.
4. Check all painted surfaces for bare metal.
a. If bare metal is showing, paint with primer or
solvent-based paint.
b. If rust appears, remove it with sandpaper or
by chemical means. Then paint with primer or
solvent-based paint.
5. Clean steam filter, where applicable.
a. Turn off steam supply and allow time for
valve to cool.
b. Unscrew nut.
c. Remove element and clean.
d. Replace element and nut.
P045I
1 Drive Motor
2 Drive Pulley
3 Belt
4 Straight Edge
5 Drive Pulley
1
2
3
4
5