Specifications

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Maintenance
C003292ENR1
44
Weekly
1. Check machine for leaks.
a. Start an unloaded cycle to fill machine.
b. Verify that door and door gasket do not leak.
c. Verify that drain valve is operating and that
drain system is free from obstruction. If water
does not leak out during prewash segment,
drain valve is closed and functioning properly.
Monthly
NOTE: Disconnect power to machine at its source
before performing monthly maintenance
procedures.
Keep the following lubricants on hand for periodic
maintenance of machine.
1. Each month or after 200 hours of operation,
lubricate bearings using grease fittings located in
upper rear panel. Pump grease gun slowly, using
full strokes. Use the following schedule to
determine number of strokes to use for machine.
The grease must have the following
characteristics:
• NLGI Grade 2
(Recommended: Shell Alvania
®
#71125)
• Lithium-based
• Water-insoluble
• Anti-rusting
• Anti-oxidizing
• Mechanically stable
The grease must have adequate base oil viscosity
with one of the following ratings:
• ISO VG 150 (709 – 871 SUS at 100°F or
135 – 165 cSt at 40°C)
• ISO VG 220 (1047 – 1283 SUS at 100°F or
198 – 242 cSt at 40°C)
• An SAE 40 rating is also acceptable as long as
cSt or SUS values are within specified ranges.
If machine is fitted with SKF System 24
®
automatic
lubricators, check that they are functioning by noting
piston position each month. Set them to dispense their
contents over 12 months for all machine models.
Always mark new lubricators with installation date.
2. Inspect drive belts for uneven wear, frayed edges
or cracking. Push on belts and make sure motor
can move about its pivot point (this ensures belts
are automatically being tensioned correctly).
Main
Bearings
Shell Alvania
®
71125 Grease
Motor
Motor bearings are sealed and do not
require service.
Door
Latch
Silicon Spray Grease
Door
Handle
Silicon Spray Grease
Table 17
Machine
type
Number of strokes per
month or 200 hours of
operation
Front
Bearing
Rear
Bearing
40M, 60M 2 1
40H, 60H, 80M, 100M 2 2
80H, 100H, 125H, 140M 3 2
140H, 175H 4 2
Table 18
Never mix grease types (Ex. Silicon,
Petroleum, Lithium, Poly-Urea)! Never use
any grease other than that specified at the
grease fittings on the machine. Doing so
may cause premature bearing failure and
void any applicable warranties.
W694
WARNING