Specifications

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
43
C003292ENR1
Maintenance
Maintenance procedures described below will prolong
life of machine and help prevent accidents.
Daily
Beginning of Day
1. Check door interlock before starting operation:
a. Attempt to start with door open. Machine
should not start.
b. Close door without locking it and attempt to
start. Machine should not start.
c. Close and lock door and start a cycle. Attempt
to open door. Door should not open.
If door lock and interlock are not functioning
properly disconnect power and call a service
technician.
IMPORTANT: Door lock should be checked daily
to ensure proper operation. Also, check that all
safety and instruction labels are on the machine.
Replace as necessary.
2. Inspect water inlet valve hose connections on
back of machine for leaks.
3. Inspect steam hose connections for leaks (where
applicable).
4. Inspect all chemical inlets, lines and connections
for leaks.
5. Verify insulation is intact on all external wires
and all connections are secure. If bare wire is
evident, call a service technician.
End of Day
1. Clean AC drive filter:
a. Remove external plastic cover which contains
filter.
b. Remove foam filter from cover.
c. Wash filter with warm water and allow to air
dry. Filter can be vacuumed clean.
IMPORTANT: The control module cover and fan
filter must be in place for the fan to properly cool
the AC inverter drive. Failure to observe this
warning will void the warranty and could lead to
expensive AC inverter drive repair.
2. Clean door gasket of residual detergent and all
foreign matter.
3. Clean supply cup dispenser and lid inside and out
with mild detergent. Rinse with clean water.
4. Clean machine’s top, front and side panels with
mild detergent. Rinse with clean water.
NOTE: Unload machine promptly after each
completed cycle to prevent moisture buildup. Leave
loading door open at end of each completed cycle to
allow moisture to evaporate.
Sharp edges can cause personal injury.
Wear safety glasses and gloves, use
proper tools and provide lighting when
handling sheet metal parts.
W366R1
WARNING
Replace all panels that are removed to
perform service and maintenance
procedures. Do not operate the machine
with missing guards or with broken or
missing parts. Do not bypass any safety
devices.
SW019
CAUTION
Do not spray the machine with water. Short
circuiting and serious damage may result.
W782
WARNING
To reduce the risk of electrical shock, serious
injury or death, disconnect the electrical power to
washer-extractor before examining the wiring.
W636
WARNING
Do not clean the cooling fans with
compressed air! Doing this spins the fan
too fast and will cause premature fan
failures.
W695
WARNING