Specifications

Specifications and Dimensions

C003292ENR1

Water Connection

Water service should have the following:

• Hot water temperature should be a maximum of

190°F (88°C).

• Water pressure should be between 30 and 85 psi

(2 to 7 bar).

• Install screen filters in water supply lines to keep

rust, grit or other foreign material out of solenoid

valves.

• Suitable air cushions (risers) should be installed

in supply lines to prevent “hammering.” Refer to

Figure 14.

To connect water feeders to rear of machine, use

flexible hoses. Because this is a vibrating machine,

water lines must allow for movement or leaks may

result. Hang hoses in a large loop behind machine so

that they are not kinked or pinched.

For machines labeled with the CE mark, backsiphon

protection devices must be installed previous of all

machine water inlet valves in accordance with

accepted European standards.

To prevent personal injury, avoid contact

with inlet water temperatures higher than

125° Fahrenheit (51° Celsius) and hot

surfaces.

W748

WARNING

P038I

1 Air Cushions (Risers)

2 Water Supply Faucets

Figure 14

P038I