Instruction manual

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Testing Machine and Electronic Control Functions
93
802953
Table 18 (continued)
Production Test Cycle Quick Reference Chart
Display Test Mode Comments
PunP or drAi Pump/Gravity Drain Test Pump is turned on or gravity drain is opened. The control will not advance
to next step until pressure switch is closed indicating drum is empty and
PERM PRESS 60 keypad is pressed.
Step Time in
Minutes
Clothes Spin The control runs a spin step. The drum will ramp up to 650 RPM for
3 minutes then 1000 RPM for 1 minute. The control will advance to the
next step when finished.
01 Door Unlock Door Lock is unpowered. The door will take approximately one minute to
unlock. When the door unlocks, the control will advance to the next step.
LoAd Load Weight The control will remain in this step until the loading door is closed and the
START (enter) keypad is pressed.
LoAd Door Lock Door Lock is powered. Machine will remain in this step until door is
locked.
RPM speed
displayed
Spin Test Machine steps through all spin speeds for 30 seconds at each speed. Speeds
are 90, 500, 650, and 1000. After 1000 RPM step, motor will stop.
brAy Breakaway Motor runs at Regular Agitate speed until door is unlocked. When door
unlocks, control will exit test.
Table 18