Instruction manual

Testing Machine and Electronic Control Functions
802953
90
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Configuration #1 Display Test
This option shows the machine configuration values.
To start test, control must be in the Testing Mode.
Refer to How to Enter Testing Feature at the
beginning of this section.
To enter, press the START (enter) keypad. For
configuration value #1, the display will show “A0XX”.
“XX” is a number corresponding to whether or not coin
drops are connected, or a card reader or network board
are connected. Refer to Table 17.
To exit a Configuration Display Test, press the
DELICATES 30 (<) keypad. The control will return to
the testing mode.
Configuration #2 Display Test
This option shows the machine configuration values.
To start test, control must be in the Testing Mode.
Refer to How to Enter Testing Feature at the
beginning of this section.
To enter, press the START (enter) keypad. For
configuration value #2, the display will show “b0XX”.
“XX” is a number corresponding to whether or not
gravity drain jumper is present.
0 = Gravity drain jumper is not present. The
machine is equipped with a pump.
16 = Gravity drain jumper is installed. The machine
is equipped with a gravity drain.
To exit a Configuration Display Test, press the
DELICATES 30 (<) keypad. The control will return to
the testing mode.
Machine Configuration Table
CONFIG
VALUE
COIN HEADER
PRESENT
NETWORK
BOARD
PRESENT
CARD
READER
PRESENT
COIN DROP
#2
PRESENT
COIN DROP
#1
PRESENT
16 OFFOFFOFFOFFOFF
17 OFFOFFOFFOFF ON
18 OFF OFF OFF ON OFF
19 OFF OFF OFF ON ON
20 OFF OFF ON OFF OFF
21 OFF OFF ON OFF ON
22 OFF OFF ON ON OFF
23 OFF OFF ON ON ON
24 OFF ON OFF OFF OFF
25 OFF ON OFF OFF ON
26 OFF ON OFF ON OFF
27 OFF ON OFF ON ON
28 OFF ON ON OFF OFF
29 OFF ON ON OFF ON
30 OFF ON ON ON OFF
31 OFF ON ON ON ON
80 ON OFFOFFOFFOFF
81 ON OFF OFF OFF ON
82 ON OFF OFF ON OFF
83 ON OFF OFF ON ON
84 ON OFF ON OFF OFF
85 ON OFF ON OFF ON
86 ON OFF ON ON OFF
87 ON OFF ON ON ON
Table 17 (continued)