Instruction manual

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming Control
81
802953
31. IR Access (On/Off) “IrA”
This option allows the owner to enable or disable
allowing the control to be read by an external device.
How to Program the IR Access (On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “Prog” appears in the
display. Press the START (enter) keypad and
“AtS1” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “IrA” appears in the
display.
4. When “IrA” appears in the display, press the
START (enter) keypad. The current IR Access
status will appear in the display.
“on” = Option Enabled (factory default setting)
“oFF”= Option Disabled
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to change the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, “rAEn”, will appear in the display.
NOTE: To program “rAEn” (Manual Rapid
Advance [On/Off]), refer to option 32. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
32. Manual Rapid Advance (On/Off)
“rAEn”
This option allows the owner to enable or disable the
rapid advance feature. Refer to Rapid Advance
Feature section for more information.
How to Program the Manual Rapid
Advance (On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “Prog” appears in the
display. Press the START (enter) keypad and
“AtS1” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “rAEn” appears in
the display.
4. When “rAEn” appears in the display, press the
START (enter) keypad. The current Manual
Rapid Advance status will appear in the display.
“on” = Option Enabled (factory default setting)
“oFF”= Option Disabled
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to change the current status.
6. Press the START (enter) keypad when the
desired status appears in the display. The next
option, “dAEn”, will appear in the display.
NOTE: To program “dAEn” (Manual Diagnostics
[On/Off]), refer to option 33. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
>
<
>
<
>
<
>
<
>
<
>
<