Instruction manual

Programming Control
802953
70
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
How to Program Cycle Modifier B Option
“CnP3”
This option allows the owner to enable or disable the
Cycle Modifier B Option.
1. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable Cycle Modifier options until
“CnP3” appears in the display.
2. When “CnP3” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current Cycle Modifier B Option value. Refer to
Table 11.
3. Locate the desired number in the first column of
Table 11.
4. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
current number until correct.
5. Press the START (enter) keypad when the
desired number appears in the display. The next
Cycle Modifier option, “CnP4”, will appear in
the display.
NOTE: To program “CnP4” (Cycle Modifier C
Option), continue to next Cycle Modifier option. To
program other options, press the DELICATES
30 (<) keypad and refer to the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
How to Read Table 11
To determine the correct number required to program
the Cycle Modifier Option, use the following chart.
The Cycle Modifier Value column contains the
number required in step 3. The other columns
correspond to individual options.
Each column of options contains a unique combination
of the words “ON” and “OFF” that indicates if that
column’s option is turned on or off when the Cycle
Modifier Value is entered. Select the desired
combination of options and enter the number found in
the Cycle Modifier Value column.
The default programmed at the factory is 2 for the
Cycle Modifier B Option and 3 for the Cycle Modifier
C Option.
>
<
>
<
Cycle
Modifier
Value
Prewash
Extra
Rinse
Extra
Wash
Warm
Rinse
0 OFF OFF OFF OFF
1 ON OFF OFF OFF
2* OFF ON OFF OFF
3** ON ON OFF OFF
4OFFOFFON OFF
5 ON OFF ON OFF
6OFFON ON OFF
7 ON ON ON OFF
8OFFOFFOFFON
9 ON OFF OFF ON
10 OFF ON OFF ON
11 ON ON OFF ON
12 OFF OFF ON ON
13 ON OFF ON ON
14 OFF ON ON ON
15 ON ON ON ON
*Factory default setting for B.
**Factory default setting for C.
Table 11