Instruction manual

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming Control
67
802953
22. Special Vend D Days Enable
“SPd-”
This option allows the owner to enable or disable a
fourth special vend.
Special Vend D can be programmed using an external
device or network.
How to Program Special Vend D Days
Enable
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “Prog” appears in the
display. Press the START (enter) keypad and
“AtS1” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “SPd-” appears in
the display.
4. When “SPd-” appears in the display, press the
START (enter) keypad. The current Special Vend
D Days Enable status will appear in the display.
“on” = Option Enabled
“oFF” = Option Disabled (factory default
setting)
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to change the current status.
6. Press the START (enter) keypad when the correct
status appears in the display. The next option,
“CnP-”, will appear in the display.
NOTE: To program “CnP-” (Cycle Modifier
Programming), refer to option 23. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
>
<
>
<
>
<