Instruction manual

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming Control
39
802953
Programming Fill/Agitate Step
1. When “AgIt” appears in the display, press the
START (enter) keypad. The first Fill/Agitate step
programming option will appear in the display.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable Fill/Agitate step options. Refer to
Table 7.
3. Press the START (enter) keypad when the
desired option appears in the display. The current
status/value will appear in the display. Refer to
Table 7.
4. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to change the current status/
value.
5. Press the START (enter) keypad when the
desired status/value appears in the display. The
next Fill/Agitate step option will appear in the
display.
NOTE: To program “drAn” (Drain Step), press the
DELICATES 30 (<) keypad and continue to next
Cycle Stage option. To program other options,
press the DELICATES 30 (<) keypad and refer to
the appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
Programming Drain Step
1. When “drAn” appears in the display, press the
START (enter) keypad. “SPry” will appear in the
display.
2. Press the START (enter) keypad.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to change the current status.
“on” = Cold Spray is enabled (factory default
setting for stage 4)
“oFF” = Cold Spray is disabled (factory default
setting for all other stages)
4. Press the START (enter) keypad when the
desired status appears in the display.
NOTE: To program the next cycle Programming
option “FSPI” (Final High Spin Step), press the
DELICATES 30 (<) keypad twice and continue to
next option. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
>
<
>
<
>
<