Instruction manual

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming Control
31
802953
7. Default Cycle “dCYC”
This option allows the owner to set the default cycle
that the machine will enter when in the Ready Mode.
When programming the default cycle, refer to Table 3.
How to Program Default Cycle
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “Prog” appears in the
display. Press the START (enter) keypad and
“AtS1” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “dCYC” appears in
the display.
4. When “dCYC” appears in the display, press the
START (enter) keypad. A number will appear in
the display. This number corresponds to the
current default cycle value. Refer to Table 3. The
cycle LED that corresponds to the selected cycle
also will be lit.
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
current number to the desired number selected
from Table 3.
6. Press the START (enter) keypad when the correct
number appears in the display. The next option,
“oPL”, will appear in the display.
NOTE: To program “oPL” (OPL Mode), refer to
option 8. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
How to Read Table 3
To determine the correct number required to program
Default Cycle, use the following table. The Default
Value column contains the number required in step 5.
The other column corresponds to Cycle Type.
The default cycle programmed at the factory is 4,
PERM PRESS 60.
>
<
>
<
>
<
“dCYC”
Default
Value
Cycle Type
1Normal 90
2Normal 60
3Normal 40
4* Perm Press 60
5 Delicates 30
6 Delicates Cold
*Factory default setting.
Table 3