Instruction manual

Programming Control
802953
26
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
2. Coin #1 Value “dEn1”
This option allows the owner to set a specific
numerical value for a coin entered. For example, in the
European Union the coin value for one euro would be
measured in cents (100). Therefore, the coin value
entered for one euro would be 00100.
If the Vend Price #1 (option 1) is set for “200”, and
the Coin Value is set for “00100”, the vend price
displayed will decrease by 100 for each one euro coin
entered.
How to Program Coin #1 Value
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until “Prog” appears in the
display. Press the START (enter) keypad and
“AtS1” will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until “dEn1” appears in
the display.
4. When “dEn1” appears in the display, press the
START (enter) keypad. There are five digits in
the Coin #1 Value. The fifth digit will appear in
the display and will flash one second on, one
second off. Refer to Figure 11.
NOTE: If the vend price is 10000 or more, the fifth
digit is “1-6”. If the vend price is 9999 or less, the
fifth digit is “0”.
Figure 11
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the fifth digit.
NOTE: The coin value can be set from 1 to 65,535.
The factory default setting is 25.
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE: To go back to the current programmable
option without changing the value, press the
DELICATES 30 (<) keypad.
7. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the active digit and the START (enter)
keypad to enter the value of the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, “dEn2”, will
appear in the display.
NOTE: To program “dEn2” (Coin #2 Value), refer
to option 3. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
CHM507R
>
<
>
<
>
<
>
<