Operating instructions

Operation

WE-8 Control

WE-8 Control Panel

M172_SVG

1. Keypad

2. Display

3. Emergency Stop Button

4. Key Switch

5. Serial Port

Figure 2

Load the Machine

1. For 18 - 75 pound models: Pull the door handle towards you

to open the door. Some models may have a door handle with a

button that must be pressed.

2. For 100 - 200 pound models: Push on the doorlock system to

open the door.

3. Load the drum to the specified capacity.

4. Close the door by pushing the door handle towards the ma-

chine.

Start a Program

1. After powering up the control, “Cycle 00” will show on the

display.

2. Press the desired program number (example: program 23).

a. The display will show the cycle (example: “Cycle 23”).

3. Press “Start” to run the program.

a. If the program does not exist, the display will show “No

Cycle 23”. See program mode to create a program.

b. If the door is not closed, the display will show “Please

close door”. The program will start once the door is

closed.

c. If the door is closed and the program exists, the program

will start. The name of the program will show on the dis-

play for 2 seconds and the machine will start.

When the machine is started, the display will show the following

information:

S01: Step 1

C23: Program number 23

50M55: The remaining time of the cycle.

80°F: The temperature of the bath that is programmed.

Delayed Start

1. Select the cycle you want to start.

Operation

D1385ENR6