Operating instructions

B-Series Control Panel

60C 60C

40C 40C

95C 95C

30C

CHM488R_SVG

1. Cycle 1

2. Cycle 2

3. Cycle 3

4. Cycle 4/Up Edit

5. Cycle 5

6. Cycle 6

7. Cycle 7

8. Cycle 8/Down Edit

9. START (enter) Keypad

10. LED (not in use)

11. Door Step LED

12. Spin Step LED

13. Rinse Step LED

14. Add Bleach LED

15. Decimal for Pricing

16. Decimals for Pricing

Figure 17

If the version of control in machine is capable of reading temper-

ature, pressing the START (enter) keypad while a wash is run-

ning will cause the display to show temperature and will revert to

minutes remaining after several seconds.

Operating Instructions - B-Series Control

1. Open the door by pulling the door handle toward you.

2. Load the machine. Refer to Figure 18 .

Load the washer-extractor to full capacity whenever possible, but

do not exceed the rated dry-weight capacity of the machine if the

fabric to be washed is dense, closely woven or heavily soiled.

Overloading the machine can result in an inferior wash. The op-

erator may need to experiment to determine the optimum load

size based on the fabric content, soil content and level of cleanli-

ness required.

Do not underload the machine. Underloading can result in out-of-

balance conditions and may lead to premature bearing and seal

failure.

CHM2273N_SVG

Figure 18

3. Close the door by pushing the door handle toward the ma-

chine. Refer to Figure 19 .

Operation

D1385ENR6