Operating instructions

ManualsBrandsAlliance Laundry Systems ManualsWasherB-Series

a. Press and hold the Start keypad for at least 3 seconds.

2. Enter the number of hours to delay start.

3. Press the Start keypad.

4. Enter the number of minutes to delay start.

5. Close the door.

6. Press the Start keypad.

The delayed start time is shown in the display.

Special Options in Run Mode

S01 C23

60°F PW HIGH

49M20

Figure 3

High: The water level in step 1 that is programmed. Refer to Fig-

ure 3 .

Display

Temp

Erase

Cycle

Figure 4

1. While the machine is running, press the “Display Temp” but-

ton. . Refer to Figure 4 .

Level: 2.5 cm: Water level in the bath. If the machine is filling

with water, this value will increase. If the machine is draining,

this value will decrease.

62°F: The water temperature.

40 rpm: The measured rpm of the drum.

L: Rotation direction of the drum

L (left), R (right)

2. Press the “Display Temp” button to go back.Refer to Figure

4 .

Advance Mode

Advance

Add Cycle

Figure 5

Press the “Advance” button to proceed to the next step in the pro-

gram. Refer to Figure 5 .

Chemical Hold Feature

Chemical supply injection can be paused. Refer to section Setup

of the Chemical Hold Feature in Programming manual.

Stop the Machine

Figure 6

Press the “Stop” button. Refer to

Figure 6 .

If there is water in the machine, the display will show “Waterle-

vel xx.x cm” while the machine is draining the water.

If the machine is spinning, the display will show “Coast down”.

When the water is out and the drum has stopped moving, the dis-

play will flash between “Please open door” and “Done cycle 23”

until the door is open.

Error Messages

Door Error

Door error

Figure 7

If the door is closed after start, the control will try to lock the

door. If the door will not lock, “Door error” will display. Refer to

Figure 7 .

Possible Faults:

• Wiring is not connected properly.

• Coil to lock the door has failed.

• Door lock has a mechanical problem.

Fill Alarm

Didn’t fill

within time

Figure 8

If machine does not reach programmed water level within time

programmed for step, a fill alarm occurs. Machine will continue

filling and agitating, while sounding beeper and flashing “Didn’t

fill within time” on display. Refer to Figure 8 .

Condition will continue for up to two (2) minutes. If programmed

water level is reached before two minute fill alarm time ends,

condition ends, and machine resumes operation.

Operation