Service manual

50 M411433

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the tumbler before servicing.

• Close gas shut-off valve to gas tumbler before servicing.

• Close steam valve to steam tumbler before servicing.

• Never start the tumbler with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the tumbler is properly grounded.

W002

WARNING

59. LOADING DOOR SWITCH

a. Remove control panel.

b. Disconnect wires from door switch.

c. Remove two switch attaching screws and

remove switch. Refer to Figure 25.

NOTE: Refer to wiring diagram when rewiring

door switch.

60. LOADING DOOR SWITCH ROD

a. Remove control panel.

b. Unlock, open and remove lint panel. Set aside

to prevent damage.

c. Open loading door, support door and remove

upper hinge bolt holding door to hinge bracket,

Figure 21.

NOTE: Nylon washer must be in place on lower

hinge pin when reinstalling door.

d. Remove door from bracket.

e. Support front panel and remove screws (and

three speed nuts) holding front panel to tumbler

cabinet. Refer to Figure 24.

f. Remove nut, washers and spring clip holding

switch rod to backside of front panel.

g. Apply upward pressure on the welded clip to

allow switch rod snap free. Refer to Figure 26.

Figure 25

T034SE1C

DOOR

SWITCH

SCREWS

Figure 26

T036SE1B

DOOR

SWITCH

ROD

SPRING

CLIP