Service manual

9001900 59

Troubleshooting

18. Excessive Cycle Time

The time programmed

for one or more of the

machine's cycles is

excessive.

Are any of the

cycle's fill times

excessively

long?

Refer to the "Fill

Alarm Analysis"

flowchart.

Yes

Are any of the

programmed fill

times

excessively

long?

Reprogram the excessively long

cycle times to shorten them as

needed.

NOTE: All pre-programmed fill

times are for 5 minutes. Any fill

should easily complete during

this time.

Yes

Are any of the

programmed

drain times

excessively long

(i.e., greater than

1 minute)?

Reprogram the excessively

long cycle times to shorten

them as needed.

NOTE: Any drain step

should not exceed 30-40

seconds.

Check the cycle for unnecessary steps.

For example, in the first fill of a cycle, if "S02 CXX 0:0045" "SUPPLY1" is programmed for 45

seconds and "S03 CXX 0:00:45" "Supply2" is programmed for 45 seconds, the two steps can be

accomplished together at the same time, saving 45 seconds. Refer to the "Programming Multiple

Supply Steps" section of the programming manual that was supplied with your machine.

Yes

CFD2007S