Specifications
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F8429301ENR9
72
2. For 80 through 125 pound capacity models
only, lubricate bearings and seals each month OR
after every 200 hours of operation.
a. Use a premium-grade lithium-based #2
grease. Never mix two types of grease, such
as petroleum and silicone.
b. Pump the grease gun slowly, permitting only
the following number of strokes:
Bearing grease fittings, 2 strokes each
Seal grease fitting, 2 stroke (125 pound
models only)
NOTE: Do not pump the grease gun until grease
comes out of the bearing housing. This can result in
over lubrication, causing damage to bearings and
seals.
3. Check overflow hose and drain hose for leaks.
4. Check the supply dispenser hoses and hose
connections.
5. Clean inlet hose filter screens:
a. Turn water off and allow valve to cool, if
necessary.
b. Unscrew inlet hose and remove filter screen.
c. Clean with soapy water and reinstall. Replace
if worn or damaged.
Quarterly
NOTE: Disconnect power to the machine at its
source before performing the quarterly
maintenance procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Tighten anchor bolts, if necessary.
3. Verify that the drain motor shield is in place and
secure, if so equipped.
4. Clean customer-supplied steam filter, where
applicable. Refer to Figure 61.
a. Turn off steam supply and allow time for the
valve to cool.
b. Unscrew cap.
c. Remove element and clean.
d. Replace element and cap.
Figure 61
5. Check the bearing mounting bolts to make sure
they are torqued properly. Refer to Table 3 9.
6. Tighten motor mounting bolt locknuts and
bearing bolt locknuts.
7. Vacuum lint from motor vents.
8. Clean all electronic boards of moisture and dust
with canned air.
9. Verify the insulation is intact on all external wires
and that all connections are secure. If bare wire is
evident, call a service technician.
10. Clean AC drive cooling fan blades (where
applicable).
H042I
1 Cap
2 Steam Filter Element
Machine
Capacity
Bearing Torque
20
All 41 ft.-lbs.
30-40
All 101 ft.-lbs.
60
All 201 ft.-lbs.
80-100
All 357 ft.-lbs.
125
All 201 ft.-lbs.
Table 39
H042I
1
2