Specifications

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
70
F8429301ENR9
Maintenance
IMPORTANT: Replace all panels that are removed
to perform service and maintenance procedures.
Do not operate the machine with missing guards or
with broken or missing parts. Do not bypass any
safety devices.
Daily
IMPORTANT: Door lock should be checked daily
to ensure proper operation. Also check that all
safety and instruction stickers are on the machine.
Any missing or illegible safety instructions stickers
should be replaced immediately.
Beginning of Day
1. Check door interlock before starting operation:
a. Attempt to start the machine with the door
open. The machine should not start.
b. Close the door without locking it and start the
machine. The machine should not start.
c. Attempt to open the door while the cycle is in
progress. The door should not open.
If the door lock and interlock are not functioning
properly, disconnect power and call a service
technician.
2. Inspect water inlet valve hose connections on the
back of the machine for leaks.
3. Inspect steam hose connections for leaks (where
applicable).
4. Inspect all chemical inlets, lines and connections
for leaks.
End of Day
1. Clean the door gasket of residual detergent and
all foreign matter.
2. Clean the door glass with a damp cloth.
3. Clean automatic supply dispenser lid and general
area.
4. Clean the machine’s top, front and side panels
with mild detergent. Rinse with clean water. DO
NOT use products that contain alcohol on the
control panel.
5. Inspect and clean basket.
6. Clean the AC drive box filter(s) weekly or more
frequently as needed (where applicable):
a. Wash the filter with warm water and allow
filter to air dry. As an alternative, the filter
may be vacuumed clean.
NOTE: Unload the machine promptly after each
completed cycle to prevent moisture buildup. Leave
loading door open after each completed cycle to
allow moisture to evaporate.
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill the machine.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating and
that the drain system is free from obstruction.
If water does not leak out during the first
wash segment, the drain valve is closed and
functioning properly.
2. Clean the AC drive box filter(s) weekly or more
frequently as needed (where applicable):
a. Wash the filter with warm water and allow
filter to air dry. As an alternative, the filter
may be vacuumed clean.
IMPORTANT: The control module cover and fan
filter must be in place for the fan to properly cool
the AC inverter drive. Failure to observe this
warning will void the warranty and could lead to
expensive AC inverter drive repair.
Sharp edges can cause personal injury.
Wear safety glasses and gloves, use
proper tools and provide lighting when
handling sheet metal parts.
W366R1
WARNING
Do not spray the machine with water. Short
circuiting and serious damage may result.
W782
WARNING