Specifications

Installation
61
F8429301ENR9
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Steam Requirements
(Steam Heat Option Only)
For machines equipped with optional steam heat,
install piping in accordance with approved commercial
steam practices. Steam requirements are shown in
Table 35.
IMPORTANT: Failure to install the customer
supplied steam filter may void the warranty.
Supply Dispensing
IMPORTANT: Undiluted chemical dripping can
damage the machine. All chemical injection supply
dispenser pumps and dispenser tubing should be
mounted below the washer’s injection point. Loops
do not prevent drips if these instructions are not
followed.
IMPORTANT: Failure to follow these instructions
could damage the machine and void the warranty.
Steam Supply Information
Steam inlet
connection size
40 – 100 pound* 1/2 in. (13 mm)
125 pound 3/4 in. (19 mm)
Number of steam inlets 1
Recommended pressure
30 – 80 psi)
(2.0 – 5.4 bar)
Maximum pressure
80 psi
(5.4 bar)
* 20 and 30 pound models can be prep for steam and a kit is
available for conversion.
Table 35
Hot Surfaces. Will cause severe burns.
Turn steam off and allow steam pipes,
connections and components to cool
before touching.
W505
WARNING
Supply Dispensing
Capacities
20 – 100 125
Number of liquid
chemical supply signals
(OPL only)
4
4
Number of supply
compartments
4
0 or 5
(optional)
Number of external
liquid supply
connections
55
Liquid supply
connection size
3/8 in.
(8 mm)
5/8 in.
(15.9 mm)
Table 36
Dangerous Chemicals. May damage eyes
and skin. Wear eye and hand protection
when handling chemicals; always avoid
direct contact with raw chemicals. Read
the manufacturer’s directions for
accidental contact before handling
chemicals. Ensure an eye-rinse facility
and an emergency shower are within easy
reach. Check at regular intervals for
chemical leaks.
W363
WARNING