Specifications

Installation

F8429301ENR9

Electrical Installation Requirements

IMPORTANT: Electrical ratings are subject to

change. Refer to nameplate for electrical ratings

information specific to your machine.

Electrical connections are made at the rear of the

machine. The machine must be connected to the

proper electrical supply shown on the nameplate on

the rear of the machine, using copper conductors only.

IMPORTANT: Alliance Laundry Systems

warranty does not cover components that fail as a

result of improper input voltage.

Make sure the correct transformer jumper (208 Volt or

240 Volt) is in place. Refer to the “optional” Electrical

Service Conversion label located on the back of the

machine near the nameplate. Refer to Figure 43.

Figure 43

Machines are equipped with an AC inverter drives

requiring a clean power supply, free from voltage

spikes and surges. Use voltage monitor to check

incoming power.

Electrical shock hazard will result in

death or serious injury. Disconnect

electric power and wait five (5) minutes

before servicing.

W810

DANGER

Dangerous voltages are present inside

the machine. Only qualified personnel

should attempt adjustments and

troubleshooting. Disconnect power from

the machine before removing any cover

and guards, and before attempting any

service procedures.

W736

WARNING

Hazardous Voltage. Can cause shock,

burn or death. Verify that a ground wire

from a proven earth ground is connected

to the lug near the input power block on

this machine.

W360

WARNING

CHM2401N

1 Electrical Service Conversion Label