Specifications

Installation

F8429301ENR9

Elevated Pad Installation with Existing

Floor

The existing floor slab must meet minimum

requirements shown in Tabl e 13 per machine. The

floor must be reinforced concrete without voids under

slab. If the slab meets these requirements and an

elevated pad is desired, refer to Figures 21, 24, 33, and

36 and proceed to Machine Foundation and Pad

Installation section.

Elevated Base Frame Installation with

Existing Floor

The existing floor slab must meet minimum

requirements shown in Tabl e 13 per machine. The

floor must be reinforced concrete without voids under

slab. If the slab meets these requirements and an

elevated base frame is desired, refer to Figures 19, 20,

22, 23, 25, 26 and 28 and proceed to Machine

Mounting and Grouting section.

Figure 19

New Foundation

If the existing floor slab does not meet the single

machine foundation requirements per model, refer to

Figures 22, 25, 34, and 37 and proceed to Machine

Foundation and Pad Installation section.

Isolated Pad Installation

This type of installation is NOT recommended.

Installer MUST consult a Structural Engineer for

concrete specifications and requirements for

installations that will not be tied into adjacent

foundations.

IMPORTANT: The above instructions and

recommendations are conservative specifications

for a typical installation based on consultations

with a structural engineer. Alliance Laundry

Systems stands behind all installations meeting

these specifications. For alternate installation

specifications based on your soil type, location,

building structure, unique floor geometry, machine

types, and utilities, consult a structural engineer in

your local area.

CHM2412N