AF-80TBS 80 lb BROADCAST SPREADER READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT 6000777 - REV A 1/11
Safety Rules This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Read and understand all safety rules and operating instructions before using this tractor attachment. Follow all safety rules and operating instructions provided by your vehicle's manufacturer when using attachment. Before filling hopper, become familiar with the operation of this Spreader.
Carton Contents (x1) 28 (x1) (x1) (x1) 13 (x1) 7 (x3) (x1) 16 (x3) TOOLS REQUIRED FOR ASSEMBLY: • 7/16" Wrench or Socket • 2 Pliers
1 Assembly Instructions Attach Control Drawbar loosely to Spreader Body with hardware as shown. MAKE SURE WIRE BRACE IS BELOW DRAWBAR BEFORE ATTACHING ANY HARDWARE. 2 7 16 Attach Wire Brace and Brace Clip to Drawbar with hardware as shown. Tighten all hardware at this time. 16 28 13 3 Install Hitch Pin as shown and secure with Cotter Pin.
Operating Instructions Before Using Broadcast Spreader: 1. Read all Safety Rules found on page 1. 2. Make sure the drop holes in the bottom of the hopper are fully open with the Rate Control handle set on #30. If not, adjust control cable to allow for a fully open hopper at position #30. 3. Obtain proper setting for material to be used from the Setting Matrix. 4. Move stop bolt on range gauge assembly to proper setting. How to use Broadcast Spreader: 1.
Operating Instructions BROADCAST SPREADER SETTING MATRIX Look for EarthWay or Ev-N-Spred models on the bag for settings. If there is none listed, please use the comparison chart below as a guide to estimate your spreader setting. These settings are approximate and intended as a guide only. Variations in physical characteristics of material applied, speed and surface roughness may require slightly different spreader settings.
5-Year Limited Warranty EPI warrants this product free of defects in original workmanship and materials for a period of 5-Years to the end user with the original purchase receipt for at home use. If used for business, the warranty is 90-days. If a manufacturing non-conformance is found, EPI at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering, or normal wear and tear as determined by EPI.
Repair Parts 7
Notes 8
DESIGNED AND TESTED IN COLUMBUS, OHIO MANUFACTURED IN THE U.S.A.
