Instructions / Assembly

1
2
3
1
5
6
4
3
7
8
2
1
1010
11
9
2
1
2
12
13
1
Attach support bars to ramp top.
Tighten bolts at this time. Slide support bar pads
onto bars as shown.
Invert ramp bottom so that flanges face up. Place ramp top
inside the ramp bottom so that the side holes of each are in line.
Be sure to place a washer between the two ramp pieces
to allow hinge to work properly.
Note: Apply soapy water
inside support bar pad,
this will allow the pad to
slide onto the bar easier.
Note: DO NOT OVER TIGHTEN. Ramp must be able to swivel.
Repeat steps 1 and 2 for second ramp.
3
Assembly Instructions