User's Manual

User Manual
Manual No. AMSL/DMR/UM/FD 009
Rev. 00 Effective Date 12.07.2022 Page | 70
7. Troubleshooting
- In case of smoke, fire, abnormal high temperature, remove battery and power
supply and turn off detector immediately.
- In case of yellow error LED on, it may trigger the impact. Please read the manual
to release the status and restart the power; if the yellow light cannot be removed,
contact Allengers service engineer or local representative
- In case of abnormal image, calibrate detector by standard method. Contact
Allengers service engineer or local representative if error is not removed by
calibration.
- Other technical issue, contact Allengers service engineer or local representative.
- When detector cannot be turned on, please check if the battery has power or if
the DC power supply is connected.
- When the software shows that the network can't connect, please confirm the
signal of detector first. If it is wireless network, the third light needs to be solid
green to indicate that it has been connected. If the green light flashes, it means
that detector is not connected. At this time, please check the network settings of
the environment and the computer, and have successfully connected.