User's Manual

User Manual
Manual No. AMSL/DMR/UM/FD 009
Rev. 00 Effective Date 12.07.2022 Page | 43
Caution
5.1.4. Charging the Battery Pack for the Flat Panel Detector
Use the battery charger recommended by Allengers Medical Systems Ltd.
For details on operations, refer to the instruction manual for the battery
charger.
5.1.5. Installing/Removing the Battery Pack for the Flat Panel Detector
Follow the procedure below to install/remove the battery pack for the flat
panel detector. When installing/removing the battery pack, place the flat
panel detector on a flat place.
Do not remove the battery pack until a processed image appears in the
window of the image processing unit after the exposure.
Do not place the connector
on a hard surface such as
the edge of a bed.
Make sure that the connector
does not protrude from the
edge of a bed.
Do not raise the flat panel
sensor by holding only the
connector.