User's Manual

User Manual
Manual No. AMSL/DMR/UM/FD 009
Rev. 00 Effective Date 12.07.2022 Page | 22
pack, causing it to overheat, emit smoke, explode or ignite.
To charge the battery pack, be sure to use the designated battery charger
and to observe the charging conditions specified by Allengers Medical
Systems Ltd. If the battery pack is charged in other conditions (temperature
or voltage/current higher than specified, remodeled battery charger, etc.),
the battery pack may be overcharged or charged with extremely high current,
and abnormal chemical reactions may occur inside the battery pack, causing
it to overheat, emit smoke, explode or ignite.
Immediately stop charging the battery pack, if charging is not completed
within the specified time. Otherwise, the battery pack may overheat, emit
smoke, explode or ignite.
Do not use the flat panel detector near the power cable.
Do not use a faulty or broken battery charger or AC adapter.
Do not over-charge battery (temperature higher than 60%), it may burn
patient.
3.12 Battery Pack Instructions
Warning
Battery pack requires regular checkup and replacement. Battery capacity
begins to warm after a period of time.
If this equipment is not in use for while, store it with the battery pack
removed. Not removing the battery pack may cause malfunction.
Caution
The battery pack is used with the flat panel detector. Do not use them in
other combinations.
Charge the battery pack only with the designated battery charger. If the
battery pack is charged under the charging conditions (voltage, current and