User's Manual

User Manual
Manual No. AMSL/DMR/UM/FD 009
Rev. 00 Effective Date 12.07.2022 Page | 15
mixture with air or with oxygen or nitrous oxide: Equipment not suitable for use
in the presence of a flammable anesthetics mixture with air or with oxygen or
nitrous oxide
3.2 Power Supply Hazard
Warning
The power supply to the detector is AC 100 to 240V. Do not use insufficient
current or voltage of power supply, which will result in line defect in the
image, and patient need to retake.
To avoid electric shocks, users should always take the following precautions:
- Do not open any covers when it is not necessary.
- Install the equipment in a location where it will not be exposed to water.
- Check that the equipment is securely earthed.
- Check that all of the cables are completely and securely connected.
- Keep the control cabinet out of reach of patients.
Cautions
- Do not reverse connecting positive and negative power terminal, it might
cause short circuit and patient/user will be harmed.
3.3 Electric Shock Hazard
Warning
Observe the following precautions when using the cables:
- Do not touch the plug and connector with wet hands. Otherwise, electric
shock may result causing death or severe injury.
- Hold the plug or connector when removing the cable.
- Pulling the cable or carrying by holding it may damage
the cable, causing fire or electric shock.
- Do not damage or remodel the cable.
- Do not place a heavy object on the cable or lay it
under the flat panel detector. Do not step on, pull,