User Manual Grey Closet Tower
ASSEMBLY INSTRUCTIONS
13
14
15
CARE AND MAINTENANCE
TROUBLESHOOTING
• Periodically check to make certain all components are properly positioned, free from damage and
fi rmly connected.
• Use a soft, clean cloth that will not scratch the surface when dusting.
• Never use water to clean the furniture as it may damage to the fi nish.
• Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
• In the event the furniture is stained or otherwise damaged during use, it is recommended
you call a professional to repair the furniture.
• Keep furniture away from direct sunlight as it may damage the fi nish.
• It is best to keep the furniture in a climate-controlled environment. Extreme temperature and
humidity changes can cause fading, warping, shrinking and splitting of wood.
• Touch-up pen (MM) has been provided (except in Item #0339209) to repair any small nicks or
scratches that may occur during assembly or shipping. If Item #0339209 is damaged and touch-up
is required, apply a quality wood polish to the damaged surface.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Closet tower tilted. The wall hanging cleats are not level.
Reinstall the wall hanging cleats and
ensure they are level.
Closet tower can
not hang on the
wall.
The mounting hole locations are not
correct.
Reinstall wall hanging cleats; make
sure the space between two wall
hanging cleats is 39-1/2 in. and the
bottom two mounting holes location is
no less than 31-1/2 in. from the fl oor.
10 11
Lowes.com/allenandrothLowes.com/allenandroth
Wooden Stud
39-1/2 in.
Minimum 31-1/2 in.
16 in.
II
II
HH
HH
M
M
M
M
M
N
Hardware Used
15. Insert shelf pins (GG) where desired in tower, then rest
adjustable shelf (G) on top. Repeat for second adjustable
shelf (G).
Note: Ensure the shelf pins (GG) are level.
Shelf Pin
x 8
GG
Hardware Used
13. Using a stud fi nder, locate the edges of the wood
studs. Find the center line of each stud and draw a
vertical reference line on the wall over each one. Position
installation template (N) at desired location on wall.
Note: The bottom of the installation template (N) should
be no less than 31-1/2 in. from the fl oor.
Mark mounting holes with a pencil (not included) and
discard installation template (N). Drill 3/16 in. pilot holes at
marked locations. Then, with the beveled edge facing up,
attach the wall hanging cleats (M) with large fl at washers
(II) and lag bolts (HH).
14. With the help from another person, carefully hang the
unit onto wall hanging cleats (M).
Lag Bolt
Large Flat Washer
x 4
x 4
HH
II
G
G
GG
GG
Wall Hanging Installation
Shelf Installation