Installation Guide

ASSEMBLY INSTRUCTIONS

Lowes.com/allenandroth

Prepare wires by stripping 3/4 in. of insulation from

wire ends using wire strippers (not included).

Connect WHITE wire from fixture (A) to WHITE wire

from outlet box using existing wire connector or wire

connector (AA). Connect BLACK wire from fixture (A)

to BLACK wire from outlet box using existing wire

connector or wire connector (AA). Connect

BARE/GREEN ground wire from outlet box to BARE

wire from fixture (A) using existing wire connector or

wire connector (AA).

NOTE: Screw wire connectors (AA) on in a clockwise

direction.

WARNING: Never connect BARE/GREEN

ground wire to WHITE or BLACK power supply

wires.

WARNING: To reduce the risk of fire, electrical

shock or personal injury, wire connectors provided

with this light fixture are designed to accept only one

12-gauge house wire and two lead wires from the

light fixture. If your house wire is larger than

12-gauge or there is more than one house wire to

connect to the corresponding fixture lead wires,

consult an electrician for the proper size wire

connectors to use.

x 3

Hardware Used

E3 Wire Connector

Outlet Box

BARE/

GREEN

WHITE

BLACK

Make sure screws (E) are screwed completely into

mounting strap (B), then temporarily place fixture (A)

over mounting strap (B) to determine amount of

adjustment necessary for screws (E). Note: Screws

(E) should come through holes in fixture (A) just

enough so decorative nuts (C) will fit flush against

fixture (A) when mounted.

Once screws (E) are adjusted, use pliers (not

included) to tighten nuts (F) on screws (E) until nuts

(F) touch mounting strap (B).

Set fixture (A) aside.

Outlet Box