welcoming • sophisticated • inspiring 800192 APPROVED FOR USE IN WET LOCATIONS ITEM #1085704 allen + roth® is a registered trademark of LF, LLC. All Rights Reserved. WALL LANTERN MODEL #WLL105BK Français p. 11 Español p. 21 ATTACH YOUR RECEIPT HERE Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-439-9800, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. - 5 p.m., EST, Friday.
TABLE OF CONTENTS Package Contents ............................................................................................................... 2 Hardware Contents .......................................................................................................................... 3 Safety Information ............................................................................................................... 3 Preparation ...........................................................................
HARDWARE CONTENTS (shown actual size) AA BB Wire Connector Machine Screw Qty. 3 Qty. 2 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. DANGER • For your protection and safety, carefully read and understand the information provided in this manual completely before attempting to assemble, install or operate this product. Failure to do so could lead to electrical shock, fire or other injuries that could be hazardous or even fatal.
SAFETY INFORMATION WARNING • All electrical connections must be in agreement with local codes and ordinances, the National Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about your local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have supply wire rated for 140°F. Consult a qualified electrician before installation.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
ASSEMBLY INSTRUCTIONS 3. Remove mounting plate (B) and from fixture (A) by removing rubber washers (F) and mounting plate screws (C) from the edges of the fixture (A). 3 B A Save mounting plate screws (C) and rubber washers (F) for later use. C F C 4. Attach mounting plate (B) to outlet box (not included) using existing washers and outlet box screws or the machine screws (BB).
ASSEMBLY INSTRUCTIONS 5a. Unwrap BARE fixture wire from BLACK and WHITE fixture wires. Prepare wires by stripping 3/4 in. of insulation from wire ends using wire strippers (not included). 5a 5b. Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS 7. Attach fixture (A) to mounting plate (B) using the rubber washers (F) and mounting plate screws (C) previously removed (Step 3, Page 6). 7 F C A NOTE: Before tightening mounting plate screws (C) completely, use level (not included) to check fixture (A) -- adjust if necessary. B F C 8. Restore power and test fixture (A). 8 A If lights do not function, please refer to TROUBLESHOOTING. 9.
OPERATING INSTRUCTIONS 1. This fixture can function with either the wall switch or the preassembled dusk-to-dawn sensor (D). To activate the dusk-to-dawn capability, remove the sensor cap (E) from sensor (D). 1 E D NOTE: For the fixture to work properly, the wall switch to the fixture MUST be turned ON at ALL times. CARE AND MAINTENANCE • Shut off main power supply. Wipe fixture with soft, damp cloth. Use window cleaner to clean glass. Do not use an abrasive cleaner on glass or fixture.
WARRANTY The distributor warrants all of its lighting fixtures against defects in materials and workmanship for five (5) years from the date of purchase. If within this period the product is found to be defective, take a copy of the bill of sale as a proof of purchase and the product in its original carton to the place of purchase. The distributor will, at its option, repair, replace or refund the purchase price to the consumer.
