Installation Guide

ManualsBrandsallen + roth ManualsMedicine CabinetsSP5172

PREPARATION

SAFETY INFORMATION

WARNING

CAUTION

• Please read and understand this entire manual before attempting to assemble or install the

product.

• This equipment has been tested and found to comply with limits for class B digital device,

pursuant to part 15 of the FCC rules.

• This class B digital apparatus complies with Canadian ICES-003.

• Power Supply: UL & cUL AC/DC Adapter

• Input: 120V AC 60HZ

• Output: 9VDC / 1A

• Battery Cells: 6 C-type, 9V

• Night Light: 3800K Color Temperature

Before beginning assembly of product, make sure all parts are present. Compare parts with

package contents list and hardware contents list. If any part is missing or damaged, do not

attempt to assemble the product.

Estimated Assembly Time: 30 minutes (with recommended two-person installation).

Tools Required for Assembly (not included): Measuring tape, Level, Phillips screwdriver, Stud

finder.

• Safety discard all packing material.

• Keep plastic bags and small parts away from children.

• Safety glasses should be worn at all times.

• Do not load this cabinet with more than 50 lbs.

• Do not load each shelf with more than 25 lbs.

•The included plastic wall anchors are intended for use with solid wall applications

only (tile or concrete).

• Do not mix old and new betteries.

• Do not mix alkaline, standard (carbon), or rechargeable (NiCd, NiMH, etc.) batteries.

第 4 页第 5 页

Lowes.com/allenandroth Lowes.com/allenandroth

ASSEMBLY INSTRUCTIONS

Hardware Used

1a. For drywall installations: Install bottom bracket

(F) a minimum of 3 inches above your existing faucet/

vanity by inserting two long screws (GG) through

bottom bracket (F) and directly into wall studs. Note:

Ensure the marks are level before proceeding.

1b. For solid wall installations: Using bottom bracket

(F) as a guide, mark screw locations with a pencil (not

included) a minimum of 3 inches above your existing

faucet/vanity. Use a 5/16-in. drill bit (not included) and

drill a pilot hole at marked locations. Insert wall anchors

(HH) into holes, then insert long screws (GG) through

bottom bracket (F) and into wall anchors (HH).

2. Carefully position the cabinet (C) onto the bottom

bracket (F) and hold in place.

Long Screw

Wall Anchor

x 2

Side View