Installation Guide

Wire nut

x 3

Connect the fixture wires to the supply wires --

black to black (Hot), white to white (Common). Then,

wrap the ground wire from the fixture around the

ground screw on the mounting bracket assembly (CC)

and connect the ground/copper of fixture wire to the

ground wire of outlet box supply wire. Secure

connections with wire nuts (BB), then wrap connections

with electrical tape. Push all excess wire and wire

connections back into the outlet box.

Hardware Used

Starting with the LED wires (D) coming from

both rod assemblies, attach the LED wires (D)

to the LED driver wires -- black to black, white to

white. Secure with previously removed orange

wire connectors, then wrap connections with electrical

tape (not included).

Note: Any excess LED wire (D) should be cut or

re-wrapped with previously removed fasteners

before being placed back inside the canopy (A).

Lowes.com/allenandroth

Wing nut

LED Driver

Orange wire

connector

LED Driver

wire

Fixture wire

Outlet box

Rotate the preassembled wing nuts clockwise

and tighten the threaded tube assemblies (B)

to the canopy (A).

CAUTION: Two people are recommended for this step.