Installation Guide

7
8. Slide panel (C) until tabs are locked into place. Note that the
direction will be either left or right, depending on panel (C) orientation.
Slowly release xture, making sure it stays in place. Slowly release
xture, making sure it stays in place. IMPORTANT: To lock the panel
(C) in place, insert a plastic push-in fastener (II) into the predrilled hole
on the side of the panel (C).
9. To assist with one person mounting of the frame (D) a temporary
assist screw (HH) is provided. Install the assist screw (HH) in one end
of the at panel (C). Bring the wood frame (D) up, align one end against
the ceiling in line with the at panel (C) and slide it so the mounting hole
in the frame (D) goes over the assist screw (HH)
10. Bring the other end of the frame (D) up to the ceiling and insert the
long machine screw (GG) through the hole in that end into the threaded
hole in the at panel (C). While supporting the frame (D), unscrew the
assist screw (HH) from the threaded hole and replace it with the other
long machine screw (GG).
Hardware Used
Hardware Used
Hardware Used
HH
HH
GG
II
Assist Screw Qty. 1
Assist Screw Qty. 1
Machine Screw Qty. 2
Plastic push-in fastener Qty. 1
8
C
II
C
9
10
C
C
C
C
D
D
HH
HH
HH
GG
D
C
D
D