Installation Guide

INSTALLATION INSTRUCTIONS

Assembly is now complete. Install desired

faucet and drain assemblies (neither included)

if not already done at step 2. Per the manufacturers’

instructions to complete the installation.

6. To re-install drawers into vanity (A). Please fully

extend metal glide tracks, gently lower and slide

drawer box into rear glide catch, then, lower

drawer box down to completely rest on

extended glides, push plastic levers to

lock the drawer box in place.

Repeat for remaining drawers.

Note: To Adjust the drawer box height. Please

spin the adjustment wheel to the left to raise the

drawer box or spin the adjustment wheel to

the right to lower the drawer box. You can

adjust the left and right side glide heights

independently in order to find the drawers best

alignment position.

CAUTION

DO NOT force drawer or damage to glide may

occur. If drawer does not slide in with ease,

remove and try again from the start.

5. To remove drawers from vanity base (A),

fully extend drawers and locate the plastic

levers on left and right sides of the metal glide

tracks. Push the plastic levers, on both sides,

at the same time, This will disengage the

drawer box from the glides. Gently lift up on

the drawer to remove it from the glide tracks.

Set aside as these will be re-installed.