Installation Guide
4
INSTALLATION INSTRUCTIONS
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Installation Time: 45 minutes (24 hours for silicone caulk to dry).
Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone
caulk, power drill with drill bit, measuring tape, level.
1
A
WARNING
Vanity (A) MUST be secured to the wall.
Note: Clean area where the vanity (A) will
be permanently located prior to beginning
installation, ensuring the vanity (A) will not
interfere with any water supply and drain
lines once mounted.
1. With two people, carefully place vanity (A)
against the wall in its final location. Find and
mark locations of wall studs behind the
permanent location of vanity (A).
From inside vanity (A), drill hole through
vanity mounting area into wall studs.
Using mounting hardware (not included)
appropriate for your installation site, secure
vanity (A) to wall stud. If possible, secure
vanity (A) to two wall studs for increased
stability.
Note: Use preassembled levelers on feet of
vanity (A) to level the item. Twisting the levelers
counterclockwise will increase the height of vanity
(A), twisting them clockwise will decrease it.
2
2
2
A
B
1
2. To install the stone top with assembled sink to
the vanity (A). Apply silicone caulk to the
top edge of the wood cabinet. With the help
of another adult, gently lower the stone top
with assembled sink onto the cabinet. Make
sure the stone top is flush with the back side
of the wood cabinet and the stone overhang is
equal on both sides over the wood cabinet left
and right side walls. Remove any excess
caulk before allowing to dry.
At this time, use the Instruction Manual,
located in the box with the vanity top (B) to
install the sink bowl (D) to the vanity top before
moving to Step 2.
Helpful tip: it may be easier to install your
choice of faucet (not included) before securing
the vanity top (B) to vanity base (A).