User Guide

XONE:V6 User Guide 17
Booth and Record Connectors
The XLR booth output feeds the DJ’s booth amplifier / loudspeaker system.
The record output can be used to make a stereo recording of the performance.
Booth output Balanced XLR wired pin 2 hot. Output level is +10dBu
when the BOOTH level control is fully clockwise and the VU meters read ‘0’.
The booth output is not affected by the MASTER EQ or level control. Connect
to the amplifier input or speaker processor if one is used.
Although the booth output is designed for connection to balanced equipment,
it can be used with unbalanced equipment by shorting the pin 3 (cold)
connection to ground. Note that this does not apply to the master MIX OUT
XLR connections which should not be unbalanced.
Record output RCA phono connectors. These operate at the lower line
level of 316mV, -10dBV (same as -8dBu) which is suitable for connection to
most 2-track recorders. The output is sourced from the booth mix but is not
affected by the booth EQ or level control.
The booth and recording mix includes the DJ microphone signal only if it has
been routed using the rear panel MIC TO BOOTH switch.
BOOTH
R
L
RECORD
L
-10dBV