User guide

XONE VF-1 User Guide 13
Rear Panel Connectors
AC Mains Input and Fuse
Plug in the IEC mains lead with moulded plug suitable for the local
mains voltage supply. The internal power supply has a universal
input which accepts a mains voltage in the range 100V to 240V AC
50/60Hz. Make sure your local voltage is within this range.
Before plugging in, read the Important Safety
Instructions printed at the start of this user guide and the
warnings printed on the VF-1 rear panel.
The VF-1 does not have a power on/off switch. Switch on the
mains supply to power the unit.
MIDI Out and MIDI In
5 pin DIN sockets. Connect to MIDI compatible equipment using
standard 5 pin DIN (MIDI) leads. Press the Local OFF switch if
you are using the MIDI function.
Monitor Out
¼” TRS jack output. Tip = left, ring = right, sleeve = ground.
Connect to an external console or speaker monitoring system, or
plug in high impedance (>70 ohms) headphones. This lets you
preview the effect of the filter even when it is bypassed.
3
2 1
MIDI
10W MAX
50-60Hz~
REPLACE FUSE WITH SAME TYPE AND RATING
ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE
MADE IN ENGLAND BY ALLEN & HEATH Ltd
BALANCED IN
LEFT RIGHT
UNBALANCED
RIGHT
LEFT
INPUT
RL
IN
OUT
JACK OUTPUT
MIX+INVERT FILTER
OUTPUT
RIGHT
LEFT
LEFT RIGHT
BALANCED OUT
MONITOR OUT
INOUT
T500mA L
250V 20mm
FUSE
USE LEFT I/P 24dB/OCT
MONO
OFF
LOCAL
VF-1
SERIAL No:
THIS APPARATUS MUST BE EARTHED
1 5 3 4 7 8 9
6
2