User guide

12 XONE VF-1 User Guide
Rear Panel Controls
Local Off
To enable the unit to receive MIDI the local OFF switch must be
selected. This switch also re-routes the front panel VCF
Frequency control to control the filter via the MIDI processor rather
than direct..
Mix+Invert filter
Mixes the inverted (polarity reversed) filter signal and the unfiltered
input signal together and sends the difference to the TRS jack
output. Create some interesting effects by feeding this signal
through an effects unit and then mixing it back with the original in
a mixing console.
Mono
Switches the unit from 12dB/oct stereo to 24dB/oct mono.
In the normal stereo position, two valve overdrive/filters are
provided, one for the left signal, the other for right. Each filter has
a 12dB per octave slope.
When pressed the two are combined internally in series to provide
a single mono valve overdrive/filter. This provides a much steeper
24dB per octave slope, and twice the resonance. Plug a mono
source into the LEFT input. The output is presented to both the
LEFT and RIGHT output connectors.
3
2
1
MIDI
10W MAX
50-60Hz~
REPLACE FUSE WITH SAME TYPE AND RATING
ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.
WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE
MADE IN ENGLAND BY ALLEN & HEATH Ltd
BALANCED IN
LEFT RIGHT
UNBALANCED
RIGHT
LEFT
INPUT
RL
IN
OUT
JACK OUTPUT
MIX+INVERT FILTER
OUTPUT
RIGHT
LEFT
LEFT RIGHT
BALANCED OUT
MONITOR OUT
INOUT
T500mA L
250V 20mm
FUSE
USE LEFT I/P 24dB/OCT
MONO
OFF
LOCAL
VF-1
SERIAL No:
THIS APPARATUS MUST BE EARTHED
1 2 3