User guide

Allen & Heath 11 XONE:S2 User
PHONO / LINE INPUT CHANNEL
1
2
3
4
5
6
1
Phono / Line Select Switch
Selects either the RCA phono input or the alternative
RCA stereo line input. In the up position PHONO is
selected, when pressed LINE is selected.
2
Channel Level Control
This control has a range of –10 to +4dB dependant upon
the channel trim. Use it to adjust the signal level of an
audio source to give a nominal 0dB reading on the chan-
nel meter, with the peak level at or below 6dB. Turn
LEVEL down if the +10 peak meter starts flashing.
3
Channel Equalizer / Isolator
The Xone:S2 is equipped with a very powerful 3 band
EQ stage providing a controlled +6dB of boost when
fully clockwise, but full isolation (cut) of each band for
dramatic effect when fully anti-clockwise. Centre
frequencies are set at:
HF = 10kHz (high frequency, treble)
MF = 1.2kHz (mid frequency)
LF = 120Hz (low frequency, bass)
4
Filter On LED
The Filter On LED will illuminate when the filter is as-
signed to the selected channel.
5
Cue Switch
Press the Cue switch to listen to the channel pre-fade
signal in the headphones and see its level on the main
meters. The LED indicator next to the switch lights
when selected. The Cue LED indicator in the monitor
section also lights to warn that you are monitoring the
channel signal rather than the main mix. Press the
switch to deselect cue.