Owner's manual

INNOFADER FITTING GUIDE

Publication AP9662_1

PAGE 1
INNOFADER FITTING GUIDE Publication AP9662_1 1
PAGE 2
FITTING THE INNOFADER Warning! Dismantling your mixer could invalidate the warranty; if you are unsure of your ability to safely carry out this work then it is advised that you leave it to a qualified service technician. Tools you will need are:  T10 Torx screwdriver  T8 Torx screwdriver Ensure that the power supply has been turned off and disconnected from the unit. Clear an area to work on whilst changing the fader.
PAGE 3
Whilst holding the cross fader, using the T8 torx driver, remove the 2 screws either side of the crossfader unit from the front panel. Unplug the 4way harness from the crossfader PCB. The original fitted fader (green PCB) will be fitted as below: To fit the Innofader (red fader), unscrew the original (green PCB) fader from the mounting plate using the T8 torx driver, remove the screws from either side of the fader. Reverse the mounting plate, ensure the fader and mounting plate are in the correct way.