User Manual

Qu Mixer Reference Guide 73 AP9372 iss.8
11.16 I/O Patch Setup – dSNAKE Out
This screen presents the patching for the dSNAKE
remote audio outputs. These outputs can be mapped
from any combination of Qu mixer output sources.
The Qu mixer detects which AudioRack type is
connected. A Qu system can have up to two
AudioRacks connected. These are shown as:
dSNAKE – The first (main) AudioRack connected.
Expander – The second (expander) AudioRack.
dSNAKE outputs can be patched with or without
physical AudioRacks connected.
All Qu mixer patching is stored in Scene memories.
The Reset Mix Settings defaults are shown below:
Qu-16 Reset dSNAKE Patch
dSNAKE Qu out
1 Mix 1
2 Mix 2
3 Mix 3
4 Mix 4
5 Mix 5
6 Mix 6
7 Mix 7
8 Mix 8
Ch Qu out
9 Mix 9
10 Mix 10
11 L
12 R
Exp Qu out
1 none
2 none
3 none
4 none
5 none
6 none
7 none
8 none
The following sources can be patched:
X Unassigned
Grp Group post-fader
Mix Mix 1-10 post-fader
LR pre LR mix – pre-fader
LR post LR mix – post-fader
L+R pre LR mono sum – pre-fader
L+R LR mono sum – post-fader
MTX Matrix post-fader
PAFL Stereo PAFL monitor
Qu-24
,
Qu-32
,
Qu-Pac Reset dSNAKE Patch
dSNAKE Qu out
1 Mix 1
2 Mix 2
3 Mix 3
4 Mix 4
5 Mix 5
6 Mix 6
7 Mix 7
8 Mix 8
Ch Qu out
9 Mix 9
10 Mix 10
11 L
12 R
Exp Qu out
1 MTX1 L
2 MTX2 R
3 MTX3 L
4 MTX4 R
5 Grp1 L
6 Grp2 R
7 Grp3 L
8 Grp4 R