User Manual

Allen & Heath 34 ZED-R16 User Guide
MODES OF OPERATION
ADC
DIGITAL SIGNAL
(FIREWIRE OR ADAT)
PRESS DIG SEND = POST EQ AND DIG RETURN = PRE-INSERT
DIGITAL SEND FROM
AFTER EQ
The post EQ signal is
sent back to the DAW.
DIGITAL INPUT = PRE INSERT
The digital input from the DAW
replaces the signal from the
channel pre-amp
DAC
EXTREME FLEXIBILITY—ANALOGUE PLUG-INS!
You can even use the EQ in the ZED-R16 channel as an analogue plug-in for your Digital Audio Workstation!
To do this press both the DIG RET = PRE INS to source the channel from your DAW and the DIG SND = POST EQ,
so the output of the EQ goes back to the DAW. You may need to create a new track in your software application for
the equalised audio, otherwise a feedback loop could easily be created between the ZED-R16 and the DAW.
Create a new track in the DAW to return the EQ’d
signal, arm the track and record it as required.
Monitor the post-EQ signal either using the channel
PFL or the SOLO function in your DAW, returning the
master stereo track to the ZED-R16 in the master
section.