User Manual

Allen & Heath 7 XONE:43 User Guide

PHONO / LINE INPUT CHANNELS 1, 2, 3 and 4

Phono / Line Select Switch

Selects either the RCA phono input or the alternative

RCA stereo line input.

Channel Level Control

This control has a range from - 10dB to +10dB. Use it

to adjust the signal level of an audio source to give a

nominal 0dB reading on the channel meter, with the

peak level at or below 6dB.

Channel Equalizer / Isolator

The Xone:43 is equipped with a very powerful 3 band

EQ providing a controlled +6dB of boost when fully

clockwise, but dramatic cut of each band when fully anti-

clockwise. Centre frequencies are set at:

HF = 3.8kHz (high frequency, treble)

MF = 1kHz (mid frequency)

LF = 310Hz (low frequency, bass)

Filter Select

Press to route the channel signal through the VCF filter.

The switch will illuminate to indicate that the channel is

being sent to the filter.

X:FX Dry / Wet Send

Use this control to vary the amount of channel signal

that is sent to an external effects device connected to

the X:FX send / return on the rear panel. With this

control set to ‘dry’, none of the signal is routed to the

external effects loop. With the control in the central

position, half of the signal is sent to external effects,

while the other half is unaffected or, if filter is selected,

only the dry part of signal is filtered. With the control

set to fully ‘wet’, all of the signal is sent to external ef-

fects and the VCF filter is bypassed.

XFade Assign Switch

Used to assign the channel to either the X (left), Off

(middle) or Y (right) side of the cross-fader.