Quick Start Guide

Qu Mixer Getting Started Guide 2 AP10025 iss2

Qu Series products comply with the European Electromagnetic

Compatibility directive 2004/108/EC and the European Low Voltage

directive 2006/95/EC.

Qu Mixer Getting Started Guide AP10025 Issue 2

Allen & Heath Limited, Kernick Industrial Estate, Penryn, Cornwall, TR10 9LU, UK

http://www.allen-heath.com

Limited One Year Manufacturer’s Warranty

Allen & Heath warrants the Allen &Heath -branded hardware product and accessories contained in the

original packaging ("Allen & Heath Product”) against defects in materials and workmanship when used

in accordance with Allen & Heath's user manuals, technical specifications and other Allen & Heath

product published guidelines for a period of ONE (1) YEAR from the date of original purchase by the

end-user purchaser ("Warranty Period").

This warranty does not apply to any non-Allen & Heath branded hardware products or any software,

even if packaged or sold with Allen & Heath hardware.

Please refer to the licensing agreement accompanying the software for details of your rights with

respect to the use of software/firmware (“EULA”).

Details of the EULA, warranty policy and other useful information can be found on the Allen & Heath

website: www.allen-heath.com/legal.

Repair or replacement under the terms of the warranty does not provide right to extension or renewal

of the warranty period. Repair or direct replacement of the product under the terms of this warranty

may be fulfilled with functionally equivalent service exchange units.

This warranty is not transferable. This warranty will be the purchaser’s sole and exclusive remedy and

neither Allen & Heath nor its approved service centres shall be liable for any incidental or

consequential damages or breach of any express or implied warranty of this product.

Conditions of Warranty

The equipment has not been subject to misuse either intended or accidental, neglect, or alteration

other than as described in the User Guide or Service Manual, or approved by Allen & Heath. The

warranty does not cover fader wear and tear.

Any necessary adjustment, alteration or repair has been carried out by an authorised Allen & Heath

distributor or agent.

The defective unit is to be returned carriage prepaid to the place of purchase, an authorised Allen &

Heath distributor or agent with proof of purchase. Please discuss this with the distributor or the agent

before shipping. Units returned should be packed in the original carton to avoid transit damage.

DISCLAIMER: Allen & Heath shall not be liable for the loss of any saved/stored data in products that

are either repaired or replaced.

Check with your Allen & Heath distributor or agent for any additional warranty information which may

apply. If further assistance is required please contact Allen & Heath Ltd.

Any changes or modifications to the equipment not approved by Allen & Heath could void the

compliance of the product and therefore the user’s authority to operate it.

ALLEN&HEATH